You can use the following command for router configuration to Nvram for use at next boot up You can use the “ show ip interface brief” command in Privileged EXEC mode for checking the IP address of all interface of Cisco device. How to check the IP address of all interfaces: Router(config-if)# ip address How to enable a port or interface You can set the IP address to any Cisco device interface by using the following commands: How to set the IP address to Cisco interface: You can access the cisco router remotely by VTY lines, these are the Virtual Terminal lines for access router, you can set password on these line by using the following commands:Ībove command will set the telnet password to “Cisco”. You can set the password for protecting enable mode by following command: (Following command will set the password to cisco) You can change the cisco router name by using command hostname in global configuration mode.

In any mode, you can obtain a list of commands available on that mode by entering a question mark (?). Therefore make sure you type it in correctly. IOS commands are not case sensitive it means that you can use them in uppercase, lowercase, or mixed case, but passwords are case sensitive. Press CTRL + C key combination during the first 60 seconds of booting process. Use exit command to return in global modeĮnter reload command from privileged exec mode. Use interface command from global configuration mode Use configure terminal command from privileged exec mode Use enable command from user exec mode for entering into this mode Also Check out some best cheap routers for real practice. Once you are at CLI you can perform all Cisco Commands here.Ĭisco IOS supports numerous command modes which can be practice with packet tracer, followings are the main command modes of cisco CLI with specific commands to navigate from one mode to another. You can do it by clicking any device and then navigating to CLI tab.

To configure any device in packet tracer you are required to open or access its CLI.

Related Article: PowerShell vs Command prompt There are also some other similar software but Cisco IOS output will be same on all simulators. Here is the detailed Cisco router configuration commands list, which can be implemented with packet tracer. Packet tracer is a network simulator used for configuring and creating the virtual cisco devices and network.

Cisco packet tracer labs answers